Allied-telesis AT-MC602 Manuel d'utilisateur télécharger pdf (Page 30)

Installation

Installing the AT-MC602 Provider Unit

The AT-MC602 Provider unit can only be installed in an AT-MCR12

rackmount chassis.

Warning

To prevent exposure to electric shock, the AT-MC602 Provider Unit

must be installed in a RESTRICTED ACCESS LOCATION and

performed by QUALIFIED SERVICE PERSONNEL.

Note

For Finland, Norway, and Sweden – When the AT-MC602 and the

AT-MCR12 are used, a permanent ground conductor must be

installed on the AT-MCR12 chassis.

For installation instructions of this ground conductor, refer to the

AT-MCR12 Media Converter Rackmount Chassis Installation Manual

(PN 613-10725-00).

To install the Provider unit in an AT-MCR12 rackmount chassis, perform

the following steps:

1. Attach the unit to one of the sliders that will hold the unit in the

chassis, as shown in Figure 13.

Figure 13 Rack Mount - Set on Slider

LINE

10BaseT/

100BaseTX

PSTN

LINK

ACT

PWR

ERR

LINK

MGMT

AT-MC601

VDSL EXTENDED ETHERNET

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 64 65

Pas de commentaire

Allied-telesis AT-MC602 Manuel d'utilisateur Page 30