Allied-telesis AT-MC602 Manuel d'utilisateur télécharger pdf (Page 26)

Installation

Installing the AT-MC601 Subscriber Unit

The AT-MC601 Subscriber unit will most likely be used as a stand-alone

device, or can be used as a desktop device, or mounted onto a wall,

using the keyholes on the bottom of the unit. The screws and plastic

anchors used for mounting the unit are provided.

Using the

Subscriber Unit

on a Desktop

To use the Subscriber unit on a desktop, perform the following

procedure:

1. Remove all equipment from the package and store the packaging

material in a safe place.

2. Attach the four protective feet (provided) to each corner of the

bottom of the unit, as illustrated in Figure 6.

Figure 6 Attaching Protective Feet to the Subscriber Unit

Wall-Mounting

the Subscriber

Unit

The Subscriber unit can be mounted onto a wall using the keyholes on

the bottom of the unit. The screws and plastic anchors used for

mounting the unit are provided.

To wall-mount the Subscriber Unit, perform the following procedure:

1. If attached, remove the protective feet, data cables, and power cord

from the unit.

2. Select a wall location for the device.

LINE

10BaseT/

100BaseTX

PSTN

LINK

ACT

PWR

ERR

LINK

MGMT

AT-MC601

VDSL EXTENDED ETHERNET

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 64 65

Pas de commentaire

Allied-telesis AT-MC602 Manuel d'utilisateur Page 26