Allied-telesis AT-DC2552XS Manuel d'utilisateur télécharger pdf (Page 59)

Stack Installation Guide for AT-2552XS L2 Data Center Switch

7. Refer to Table 9 on page 56 for the recommended fiber optic cable.

Insert the cable to the port on the transceiver, as shown in Figure 28,

until it snaps in place.

Figure 28. Attaching a Fiber Optic Cable to an SFP+ Transceiver

8. Repeat steps 6 and 7 for the cable installation into the remaining SFP+

transceivers that are installed.

Installing a SFP+

Direct Attach

Cables

The AT-SP10TW1, AT-SP10TW3 and AT-SP10TW7 10G direct attach

cables come in 1m, 3m, and 7m cable lengths respectively. These SFP+

cable modules are ordered and supplied separately from the

AT-DC2552XS.

Perform the following procedure to install a SFP+ direct attach cables:

1. Remove the dust plug from a SFP+ slot on the switch. Refer to Figure

29.

Figure 29. Removing the Dust Plug from a SFP+ Slot

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 83 84

Pas de commentaire

Allied-telesis AT-DC2552XS Manuel d'utilisateur Page 59