Allied-telesis 8100S Series Manuel d'utilisateur télécharger pdf (Page 106)

Chapter 7: Cabling the Network Ports

106

Installing Optional SFP Transceivers

Review the following guidelines before installing optional SFP transceivers

in the switch:

 The SFP slots are part of combo ports, with 10/100/1000Base-T

ports. For operational information, refer to “SFP Slots” on page 34.

 SFP transceivers can be hot-swapped while the switch is powered

on. However, you should always disconnect the fiber optic cables

first before removing a transceiver.

 You should install the transceiver before connecting the fiber optic

cable.

 Fiber optic transceivers are dust sensitive. Always keep the plug in

the optical bores when a fiber optic cable is not installed, or when

you store the transceiver. When you do remove the plug, keep it

for future use.

 Unnecessary removal and insertion of a transceiver can lead to

premature failure.

Warning

A transceiver can be damaged by static electricity. Be sure to

observe all standard electrostatic discharge (ESD) precautions,

such as wearing an antistatic wrist strap, to avoid damaging the

device.

Note

The cable specifications of optional SFP transceivers are found in

the installation guides that ship with the devices.

To install an SFP transceiver:

1. Remove the dust plug from a transceiver slot on the switch. Refer to

Figure 45 on page 107.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 139 140

Pas de commentaire

Allied-telesis 8100S Series Manuel d'utilisateur Page 106