Allied-telesis AR700 Series Manuel d'utilisateur télécharger pdf (Page 36)

Features in 275-02 36

Version 275-05

C613-10473-00 REV D

CR00010240 OSPF 2

When a default route was imported into OSPF (for example, from BGP), the OSPF

defroute parameter setting was not checked.

This issue has been resolved so that if the defroute parameter is set to off, the

default route is not imported into OSPF.

Y YYYYYYYYY

CR00010241 OSPF 2

In the configuration file or output resulting from the commands create config

and show config dynamic=ospf, the command set ospf type=2 occurred

when set ospf type=1 should have occurred.

This issue has been resolved.

YYYYYYYYY

CR00010303 TCP 2

When a TCP connection was established with a router or switch, no minimum

value was enforced for the Maximum Segment Size (MSS) option in the received

SYN packet. If the value of the received MSS was zero, this could cause a reboot.

Extremely low MSS values can also cause a lot of additional overhead. For

example, if an MSS of just one byte was specified, then 40 bytes of TCP and IP

headers must also be transmitted for every one byte of TCP data—a request for

1460 bytes of data will result in 1460 packets and 59,860 bytes of data being

transmitted.

This issue has now been resolved. The router or switch now enforces a minimum

MSS of 28 bytes. This conforms to the minimum Internet datagram size of 68

bytes, as specified by RFC 791, allowing for 40 bytes of TCP/IP header

information.

Also, when the firewall was configured with multiple policies, it could send a SYN

packet with the value of zero for the MSS. This would occur if the interfaces

sending and receiving the SYN were public in one policy and private in another

policy. An example would be traffic between a private LAN and DMZ interface,

where the LAN and DMZ are configured by separate firewall policies. This issue

has now been resolved, so that a default MSS of 536 bytes is sent by the Firewall

(the minimum datagram size able to be reassembled by a host is 576 bytes, as

specified in RFC 791, minus 40 bytes of TCP/IP headers).

YYYYYYYYY

CR Module Level Description

AR400

AR7x5

AR750S

Rapier i

AT- 8 8 0 0

AT- 8 6 0 0

AT-8700XL

AT- 8 9 4 8

AT- 9 9 0 0

AT- 9 8 0 0

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 52 53

Commentaires sur ces manuels

Pas de commentaire

Allied-telesis AR700 Series Manuel d'utilisateur Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Allied-telesis AR700 Series