Allied Telesis AT-PBC18 Guide d'installation télécharger pdf (Page 36)

4. Slide the new power supply into the expansion slot, gently seating the

power supply’s connector into the chassis’ backplane.

5. Secure the new power supply to the chassis by tightening the two

thumbscrews.

Note

It is recommended that you connect the main and redundant power

supplies to separate outlets or DC circuits to increase the proctection to

your chassis from operational failure.

6. Apply power to the new module by connecting the AC power cord or DC

wires. Refer to page 11, Step 4 for an AC unit or Step 5 for a DC unit.

7. The new power supply’s LED should be ON. If the LED is OFF, refer to

“Troubleshooting” on page 31 for instructions.

The PowerBlade PBC18 is now ready for use.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 61 62

Pas de commentaire

Allied Telesis AT-PBC18 Guide d'installation Page 36