Allied Telesis AT-PBC18 Guide d'installation télécharger pdf (Page 22)

c. Strip the three wires in the cable tray coming from the DC input

power source to 8 millimeters

± 1 millimeters (0.31 inches ± 0.039

inches) using a 14-gauge wire-stripping tool.

Warning

Do not strip more than the recommended amount of wire. Stripping

more than the recommended amount can create a safety hazard by

leaving exposed wire on the terminal block after installation. ! 17

Figure 8 Stripped Wire

d. Connect the frame ground wire to the terminal marked with the

ground symbol by inserting the wire into the terminal block and

tightening the connection with a flathead screwdriver. See Figure 9.

Warning

When installing this equipment, always ensure that the frame ground

connection is installed first and disconnected last. ! 18

Figure 9 Connecting the Stripped Wire

8 mm ± 1 mm

(0.31 in ± 0.039 in)

PWR 2 PWR 1

PBM02

Management

MDI-X

MDI

LNK

STATUS

PWR

RESET

RS-232 Terminal 10Base-T

PBPWRDC

FOR CENTRALIZED DC

POWER CONNECTION,

INSTALL ONLY IN A

RESTRICTED AREA

36-60VDC , 1.0A

DC INPUT

36-60VDC , 1.0A

DC INPUT

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 61 62

Pas de commentaire

Allied Telesis AT-PBC18 Guide d'installation Page 22