Allied Telesis AR450S Guide d'installation télécharger pdf (Page 7)

Quick Install Guide 7

C613-04045-01 REV A

1. Connect the PC to a router switch port.

The PC can be connected directly, or through your LAN.

To connect the PC directly to the router, use a straight-through Ethernet

cable to connect an Ethernet card on the PC to any one of the router’s

switch ports. Note the PC’s IP address and mask.

To connect via a LAN, use a straight-through Ethernet cable to connect the

router’s switch port(s) to the device(s) on the LAN. Select the LAN PC

from which you wish to configure the router. The PC should be in the same

subnet as the part of the LAN that contains the router (for example, the PC

could be connected to a hub or Layer 2 switch that is directly connected to

one of the router’s switch ports). Note the PC’s IP address and mask.

2. Access the CLI on the router.

Follow the instructions in the previous Using the CLI to configure a router

section.

3. Enable IP.

At the CLI, enter the command:

ENABLE IP

Hub or

switch

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Allied Telesis AR450S Guide d'installation Page 7