Allied Telesis Patch 86261-04 Manuel d'utilisateur télécharger pdf (Page 4)

4 Patch Release Note

Patch 86261-07 for Software Release 2.6.1

C613-10388-00 REV G

The neighbour discovery timeout has been set to 3 seconds in ICMPv6 to

speed up Destination Unreachable detection.

The badQuery and badRouterMsg counters in the SHOW IGMP and SHOW

IGMPSNOOPING commands were not incrementing correctly. This issue

has been resolved.

When an Inter-area route went down and the only other route to the

destination was an AS-External route, the AS-External route was not

selected. This issue has been resolved.

An enhancement allows the key sequence Ctrl-Q to delete remaining text

due for output to the console when in continuous paging mode. Once the

text is cleared, the command prompt is restored.

The feature will mainly be useful when a SHOW command is executed that

generates a large amount of output, which could take several minutes to

stream to the console. It will not be effective for any commands that cause

the streaming of output to continue until another command is executed

(such as ENABLE or DISABLE DEBUG commands).

A filter entry was lost when the SET SWITCH L3FILTER ENTRY command

did not succeed. This issue has been resolved.

An enhancement adds partial support for PPP Bridging Control Protocol

(BCP). There are 10 options to this protocol, and this patch implements

option number 8. With option 8, the local or peer bridge can be enabled to

receive IEEE 802 tagged frames.

To enable the receipt of IEEE 802 tagged frames, use the command:

enable bridge tagged

This command enables BCP option 8 negotiation with the peer at the

other end of the bridge.

To disable the receipt of IEEE 802 tagged frames, use the command:

disable bridge tagged

This command disables BCP option 8 negotiation with the peer at the

other end of the bridge.

To see whether the local or peer bridge is enabled or disabled for the receipt

of IEEE 802 tagged frames, use the command:

show bridge

Link-local addresses can only be unicast addresses. If a link-local address

was added as an anycast address, no error message was returned. This issue

has been resolved. Now, an error message is returned stating that a link-

local address must be a unicast address.

PCR: 31223 Module: IPV6 Level: 3

PCR: 31224 Module: IPG Level: 3

PCR: 31230 Module: OSPF Level: 3

PCR: 31232 Module: TTY

PCR: 31233 Module: L3F Level: 2

PCR: 31235 Module: BRG, VLAN, PPP

PCR: 31236 Module: IPV6 Level: 3

1 2 3 4 5 6 7 8 9 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Allied Telesis Patch 86261-04 Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau Allied Telesis Patch 86261-04