Allied-telesis x510 Series Manuel d'utilisateur télécharger pdf (Page 63)

x510 Series Installation Guide for Stand-alone Switches

Installing SFP

Modules in the

AT-x510-28GSX

Switch

To install SFP transceivers in slots 1 to 24 of the AT-x510-28GSX Switch,

perform the following procedure:

1. Remove the dust plug from a transceiver slot on the switch. Refer to

Figure 19.

Figure 19. Removing the Dust Plug from an SFP Slot

2. Remove the transceiver from its shipping container and store the

packaging material in a safe location.

3. If you are installing the transceiver in a top slot, position the transceiver

with the Allied Telesis label facing up. If you are installing the

transceiver in a bottom slot, position the transceiver with the label

facing down.

4. Slide the transceiver into the slot until it clicks into place, as shown in

Figure 20 on page 64.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 89 90

Pas de commentaire

Allied-telesis x510 Series Manuel d'utilisateur Page 63