Allied-telesis Removable Power Supply and Fan Manuel d'utilisateur télécharger pdf (Page 11)

Removable Power Supply and Fan

Connecting a PWR01 or PWR02

1. Plug the supplied AC power cable into the power inlet on the PSU and

attach the retaining clip.

2. Connect the power cable to the main power source.

3. The PSU LED on the front panel of the switch lights green. If the LED does

not light, refer to the Hardware Reference for troubleshooting information.

Connecting a PWR05 (AC version only)

The rear grounding-terminal is not necessary for the SwitchBlade x908 when

using AC PSUs because the chassis is grounded through the power cable.

1. Form a loop in the supplied AC power cable at the PSU end and clip the

ferrite core over the looped cable, as shown in the following illustration.

This keeps the ferrite core in its correct position, close to the PSU.

Looped power cable

Ferrite core

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Pas de commentaire

Allied-telesis Removable Power Supply and Fan Manuel d'utilisateur Page 11