Allied-telesis FastPrint Server Manuel d'utilisateur télécharger pdf (Page 32)

Chapter 4. Novell NetWare

Configuration Settings

FastPrint Server User’s Guide 22

means that printer 8 corres1ponds to logical printer L1, printer 9

corresponds to logical printer L2, and so on, up to printer 15 which

corresponds to logical printer L8.

4.6.3.5.2. Configuring the FastPrint Server

Perform the following steps to define the pre-string, post-string, and the physical output

port of a logical printer:

1. Run PSCONFIG.

2. Select Change Configuration.

3. Select Logical Printer Configuration and set the following items for each logical

port. (Logical printers are numbered from L1 to L8.)

Physical port

Select the physical port for this logical printer (P1 to P3).

String before job

The printer control string (in hex) to be sent to the printer

before each print job.

String after job

The printer control string (in hex) to be sent to the printer

after each print job.

Convert LF to

CR+LF

If this is ON, LF (line feed) characters are changed to

CR+LF (carriage return + line feed). If it is OFF, no

conversion will be done.

Note: The maximum size of a printer control string is 15 characters.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 99 100

Pas de commentaire

Allied-telesis FastPrint Server Manuel d'utilisateur Page 32