Allied-telesis AT-S97 Manuel d'utilisateur télécharger pdf (Page 51)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide

SYSTEM SET CHASSIS

Syntax

system set chassis id=

chassis

name=

name

Parameters

id Identifies the ID number of the chassis. In version 1.3.0, the

chassis ID number is 0 or 31. To view the ID number of a

unit, use the SYSTEM SHOW CLUSTER command. For

instructions, refer to “SYSTEM SHOW CLUSTER” on

page 88.

name Specifies a name of up to 20 alphanumeric characters for

the chassis. Spaces are permitted, but a name with spaces

must be enclosed in double quotes (“ “). To remove the

current value without specifying a new value, enter “none”.

Privilege Levels

Administrator and read-write.

Description

This command assigns a name to a chassis. Names can makes it easier to

identify the different devices. This command is different from the SYSTEM

SET HOSTNAME command in that the latter assigns a name to an entire

stack, while this command can assign names to the individual units in a

stack. To view the current name of a chassis, refer to “SYSTEM SHOW

CHASSIS” on page 86 or “SYSTEM SHOW CLUSTER” on page 88.

Examples

This command assigns the name “interconnect51” to a chassis with the ID

number 0:

system set chassis id=0 name=interconnect51

This command assigns the name “wtc connection” to a chassis with the ID

number 31:

system set chassis id=31 name="wtc connection"

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 217 218

Pas de commentaire

Allied-telesis AT-S97 Manuel d'utilisateur Page 51