Allied-telesis AT-S95 WEB Manuel d'utilisateur télécharger pdf (Page 35)

Configuring IPv6

Page 35

To view IPv6 Neighbor entries:

1. Click System > IPv6 Neighbors. The IPv6 Neighbors Page opens.

2. Select an interface.

3. Click View. The View IPv6 Neighbors Page opens.

Figure 16: View IPv6 Neighbors Page

The View IPv6 Neighbors Page contains the following fields:

• Interface — Displays the interface (VLAN) on which the IPv6 interface is configured.

• IPv6 Address — Defines the currently configured neighbor IPv6 address. The address must be a valid IPv6

address, specified in hexadecimal using 16-bit values between colons.

• MAC Address — Displays the MAC address mapped to the IPv6 address.

• Type — Displays the type of the neighbor discovery cache information entry. The possible field values are:

– Static — Shows static neighbor discovery cache entries.

– Dynamic — Shows dynamic neighbor discovery cache entries.

• State — Displays the IPv6 Neighbor status. The field possible values are:

– Incomplete — Indicates address resolution is in process. The neighbor has not yet responded.

– Reachable — Indicates the neighbor is known to be reachable.

– Stale — Indicates the previously known neighbor is no longer reachable. No action is taken to verify its

reachability, until traffic need to be sent.

– Delay — Indicates the previously known neighbor is no longer reachable. The Interface is in Delay state

for a predefined Delay Time that if no reachability confirmation is received, the state changes to Probe.

– Probe — Indicates the neighbor is no longer known to be reachable, and Unicast Neighbor Solicitation

probes are being sent to verify reachability.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 253 254

Pas de commentaire

Allied-telesis AT-S95 WEB Manuel d'utilisateur Page 35