Allied-telesis AT-S70 Manuel d'utilisateur télécharger pdf (Page 16)

Chapter 1: Overview

Local Management Session

You establish a local management session with a Converteon chassis by

connecting a terminal or a PC with a terminal emulator program to the RS-

232 Terminal Port on the CPM card installed in the front of the chassis,

using the straight-through RS-232 management cable. This type of

management session is referred to as “local” because you must be

physically close to the chassis, such as in the wiring closet where the

chassis is located.

After the session starts, a menu is displayed from which you can make

selections to configure and monitor the chassis. You can configure all

operating parameters of a chassis from a local management session.

Note

For instructions on starting a local management session, refer to

“Starting a Local Management Session” on page 21.

A chassis does not need an Internet Protocol (IP) address for you to

manage it locally. You can start a local management session on a chassis

at any time. It will not affect the forwarding of frames by the device.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 131 132

Pas de commentaire

Allied-telesis AT-S70 Manuel d'utilisateur Page 16