Allied-telesis AT-S20 Manuel d'utilisateur Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 124
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
AT-S20 User’s Guide
1-5
6HWWLQJ#6ZLWFK#'HIDXOWV
To set your switch to the factory defaults, do the following:
Warning
This operation deletes existing switch configurations.
1. Attach a terminal or PC to the RS232 port located on the front
panel of the switch and start the terminal emulation program.
2. Press RESET located on the right side of the switch’s front panel.
3. Immediately press any key when you see
Hit any key to run
diagnostics or to reload system software
.
A menu
then displays.
4. Select
D
from the menu. The following warning message displays:
WARNING: This will erase all current
configuration data!
Continue? Y/N
5. Select
Y
.
The system displays:
All configuration data has
been reset to factory default values
.
6. Press B to boot the switch software.
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 123 124

Commentaires sur ces manuels

Pas de commentaire