Allied-telesis AT-MR815T Manuel d'utilisateur télécharger pdf (Page 29)

This chapter discusses testing AT-MR415T/AT-MR815T Micro Repeaters for a

valid connection as well as steps to detect other problems.

Performing a Connection Test

In order to test for a valid connection, as well as conﬁrm the correct operation

of the network, follow the steps outlined below. Refer to Figure 11.

Figure 11: AT-MR815T Connection Test

1. Connect port 1 and port 2 of a single AT-MR415T/AT-MR815T Micro

Repeater to two computers and turn on the HUB power supply by

connecting the AC adapter. (In Figure 11 above, PC B is connected to port 1

and PC A is connected to port 2.)

2. Check to make sure the LINK ON lamps of both port 1 and port 2 are

lighted.

3. Using your own software, conﬁrm proper communication between

machines by sending data from the computer connected to port 1 to the

computer connected to port 2. (For example, if you have installed the

CentreNET PC/TCP protocol, use the “PING” command.)

PC A

PC B

PC C

Chapter 3

Troubleshooting

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Pas de commentaire

Allied-telesis AT-MR815T Manuel d'utilisateur Page 29