Allied-telesis AT-MCF2000 Manuel d'utilisateur télécharger pdf (Page 42)

Chapter 2: Installation

Removing a Module from the Chassis

The procedures in this section explain how to remove a

module from the chassis. The procedures are:

 “Removing an AC Power Supply Module” on page 42

 “Removing a Fan Module” on page 42

 “Removing a Media Converter Module” on page 43

Removing an

AC Power

Supply

Module

To remove the AT-MCF2000AC Power Supply Module,

perform the following procedure:

1. Set the power switch on the AT-MCF2000AC module

to OFF.

2. Disconnect the AC power cord from the power source.

3. Raise the power cord retaining clip and disconnect the

power cord from the power supply module.

4. Loosen the two captive screws that secure the power

supply module to the chassis using a cross-head

screwdriver.

5. Slide the power supply module from the unit.

Caution

If the chassis is operating with a second power supply,

you must replace the power supply module you just

removed with another power supply module or the

AT-MCF2KFAN fan unit. The chassis must have either

two power supply modules or one power supply

module and one fan module to maintain adequate

airflow and cooling.

Removing a

Fan Module

The AT-MCF2KFAN fan module supports hot swapping and

can be removed while the chassis is powered on. To

remove the module, perform the following procedure:

1. Loosen the two captive screws that secure the module

to the chassis using a cross-head screwdriver.

2. Slide the fan module from the unit.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Pas de commentaire

Allied-telesis AT-MCF2000 Manuel d'utilisateur Page 42