Allied-telesis AT-GS950/24 Manuel d'utilisateur Page 324

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 366
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 323
Chapter 25: Loopback Protection
324
Configuration
To configure the Loopback Detection feature, perform the following
procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select Loopback Detection.
A partial view of the AT-GS950/24 Loopback Detection Page is
displayed. See Figure 116.
Figure 116. AT-GS950/24 Loopback Detection Page
3. For the Loopback Detection State field a the top of the page, select
one of the following radio buttons:
Enabled - This selection enables the Loopback Detection feature
across the switch. This state must be enabled for the individual
port Loopback Detection State is effective.
Disabled - This selection disables the Loopback Detection feature
on the switch.
Vue de la page 323
1 2 ... 319 320 321 322 323 324 325 326 327 328 329 ... 365 366

Commentaires sur ces manuels

Pas de commentaire