Allied-telesis AT-WCC200G Manuel d'utilisateur télécharger pdf (Page 30)

❑ Channel

It shows radio channel numbers that are used for Wireless LAN

networking.

The channel number can be set only under the Ad-Hoc operation

mode. In Ad-Hoc mode, each station must have the same channel

numbers and SSID.

In Infrastructure mode, the AT-WCC200G adapter will

automatically detect the channel number of the access point.

Under Security you can set:

❑ Network Encryption

This function is used to protect wireless communication from

eavesdropping. A secondary function of encryption is to prevent

unauthorized access to a wireless network, and it can be achieved

by using the Encryption function.

Check the Enable Encryption box to activate the security of the

AT-WCC200G adapter.

❑ Key 1 - 4:

You can type the key that you want to use from Key 1 to Key 4. The

key that you type will be the encryption between the station that

you are connected with.

If you select 64-bit in Hex format, you must type 10 values in the

following range (0 - F, hexadecimal), or 64-bit in ASCII format, you

must type 5 values in the following range (0 - 9, A - Z, and a - z

Alphanumeric).

If you select 128-bit in Hex format, you must type 26 values (0 - F,

hexadecimal), or 128-bit in ASCII format, you must type 13 values

in the following range (0 - 9, A - Z and a - z Alphanumeric).

If you select 256-bit in Hex format, you must type 58 values (0 - F,

hexadecimal), or 256-bit in ASCII format, you must type 29 values

in the following range (0 - 9, A - Z and a - z Alphanumeric).

Be sure that the AT-WCC200G adapter and the wireless station is

set to the same key.

❑ Create with Passphrase

The Passphrase helps you create a group of WEP key in the Key

Setting. If you input a phrase in the Create with Passphrase field,

the group of key setting will be changed.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Pas de commentaire

Allied-telesis AT-WCC200G Manuel d'utilisateur Page 30