Allied-telesis AT-TS24TR Manuel d'utilisateur télécharger pdf (Page 30)

TurboStack Hubs with Management

1. Every TurboStack hub is shipped with a dust cover on the

interrepeater bus port, located on the back of the TurboStack module,

to prevent static discharge and/or damage to the connector pins. Before

the module is installed in a chassis, the dust cover must be removed, as

shown in Figure 6.

2. Remove the rubber feet from the module (see Figure 7).

3. Be sure to reinstall the screws after removing the rubber feet to

prevent the module casing from expanding and warping (see Figure 8).

Figure 6: Removing

Interrepeater Bus

Dust Cover

Figure 7: Removing Rubber

Feet from Module

Figure 8: Reinstalling Screws

POWER MASTER FAULT

IEEE 802.3/ ETHERNET 10BASE 2

8 PORT HUB/ REPEATER

with Network Management

Dust Cover

Module with dust cover removed

port connector

Interrepeater bus

Module with dust cover installed

Rubber foot

(1 of 4)

Reinstall

screw

(1 of 4)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 94 95

Pas de commentaire

Allied-telesis AT-TS24TR Manuel d'utilisateur Page 30