Allied-telesis AT-S70 Manuel d'utilisateur Page 232

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 302
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 231
Chapter 9: SNMPv3
232
The following prompt is displayed:
Enter Target Parameters Name:
6. Enter a previously configured Target Parameters Name.
Enter a value of up to 32 alphanumeric characters.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
7. Select one of the following storage types for this table entry:
V-Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 Target Parameters Table to the configuration file.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Target Parameters Table to the configuration file. Allied
Telesis recommends this storage type.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Displaying the
SNMPv3 Target
Parameters Table
Menu
This section describes how to display the Display SNMPv3 Target
Parameters Table menu. For information about the SNMPv3 Target
Parameters Table parameters, see “Creating an SNMPv3 Target
Parameters Table Entry” on page 220.
To display the Display SNMPv3 Target Parameters Table menu, perform
the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Target Parameters Table.
Vue de la page 231
1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 301 302

Commentaires sur ces manuels

Pas de commentaire