Allied-telesis AT-RPS3000 Manuel d'utilisateur télécharger pdf (Page 23)

AT-RPS3000 Redundant Power Supply Installation Guide

PoE+ power is different in that the power supplies in the switch and

chassis do use load-sharing to provide power to the powered devices. This

assumes, of course, that both supplies have PoE+ power. So, in essence,

the AT-RPS3000 Chassis performs two roles for PoE+ switches. It acts as

a redundant source of system power for the switches and, assuming the

chassis has PoE+ power supplies, actively provides them with additional

power for PoE+ so that they can support more powered devices.

Of the three available power supply modules for the chassis, two modules

provide PoE+ power along with system power to the PoE+ switches. They

are the AT-PWR800 and AT-PWR1200 Modules. These modules can

provide PoE+ power to just one switch at a time, meaning that each PoE+

switch has to have a separate power module in the AT-RPS3000 Chassis,

that is, if you want the switches to receive additional PoE+ power from the

chassis.

All four RPS ports on the chassis may be used to provide system power to

the switches. But only RPS 2 and 4 ports, labeled PoE+/System, may be

used to supply PoE+ power. Thus, for a PoE+ switch to receive PoE+

power from a power supply in the chassis, it has to be connected to one of

those ports. PoE+ switches that are connected to RPS 1 or 3 port will not

receive extra PoE+ power, only redundant system power.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 91 92

Pas de commentaire

Allied-telesis AT-RPS3000 Manuel d'utilisateur Page 23