Allied-telesis AT-MC102XLPCI Manuel d'utilisateur télécharger pdf (Page 20)

Chapter 1: Product Overview

Note

Although is not marked on J4, Pin 2 is positioned between pins 1

and 3.

Note

If you choose to remove the jumper, Allied Telesis recommends that

you re-install the jumper on the center pin (2) only, 90 degrees from

the pins 1 and 3 so that it does get lost.

Table 2. Auto-Negotiation Configuration- Jumper J4 Positions

Pin Position of Jumper Feature Configuration

1 and 2 (Factory Default) Auto-Negotiation feature enabled

2 and 3 Auto-Negotiation feature disabled

No Jumper Installed Auto-Negotiation feature enabled

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Pas de commentaire

Allied-telesis AT-MC102XLPCI Manuel d'utilisateur Page 20