Allied-telesis AT-GS908 Manuel d'utilisateur télécharger pdf (Page 30)

Installation

Installing the Switch in a Rack

To install the AT-GS908 in a standard 19-inch rack, perform the following

procedure:

1. If attached, remove the rubber feet by using a flat-head screwdriver

as shown in Figure 8.

Figure 8 Removing the Rubber Feet

2. Attach a bracket to one side of the switch using the bracketmounting

screws that came with the switch. See Figure 9.

Figure 9 Attaching Rackmounting Brackets

3. Install the second rackmounting bracket on the other side of the

switch using the remaining bracketmounting screws.

4. Mount the switch in the 19-inch rack using four rackmounting screws

(not provided).

5. Refer to Step 4 on page 18 in the previous section to complete the

installation.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Pas de commentaire

Allied-telesis AT-GS908 Manuel d'utilisateur Page 30