Allied-telesis AT-FS724L Manuel d'utilisateur télécharger pdf (Page 37)

AT-FS716L & AT-FS724L Fast Ethernet Switch Installation Guide

2. Apply AC power to the switch by plugging the power cord into the AC

power connector on the back panel of the unit, as shown in

Figure 15.

Figure 15. Connecting the AC Power Connector to Switch

Warning

Power cord is used as a disconnection device: To de-energize

equipment, disconnect the power cord.  5

3. Plug the other end or the power cord into a wall outlet.

4. Verify that the POWER LED is green. If the LED is OFF, refer to

“Troubleshooting” on page 38.

The switch is ready for network operations.

1535

100-240VAC~

1 2 ... 32 33 34 35 36 37 38 39 40 41

Pas de commentaire

Allied-telesis AT-FS724L Manuel d'utilisateur Page 37