Allied-telesis AT-FS203 Manuel d'utilisateur télécharger pdf (Page 24)

Installing the Switch

Planning the Installation

Be sure to observe the following guidelines when planning the installation of

your Ethernet switch.

❑

The end node connected to the fiber optic port on an AT-FS201ST or

AT-FS202SC switch must be able to operate at 100 Mbps.

❑

The end node connected to the twisted pair port(s) can operate at

either 10 Mbps or 100 Mbps.

❑

The end node connected to a port on the switch can be a network

adapter card, repeater, router, hub, or another switch.

❑

The twisted pair cabling must be kept away from sources of electrical

noise, such as radios, transmitters, power lines, broadband amplifiers,

electrical motor, and fluorescent fixtures.

❑

Refer to Table 3 for the cabling specifications for the twisted pair

port(s).

Table 3

10/100Base-TX Twisted Pair Cabling Specifications

Operating Mode Cable Type

Maximum

Distance

10Base-T Shielded or unshielded Category 3 or better 100 m (328 ft)

100Base-TX Shielded or unshielded Category 5 or better 100 m (328 ft)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 49 50

Pas de commentaire

Allied-telesis AT-FS203 Manuel d'utilisateur Page 24