Allied-telesis AT-9724TS Manuel d'utilisateur télécharger pdf (Page 90)

Initializing Ports for Port Based 802.1x

Existing 802.1x port settings are displayed and can be configured using the window below.

Note: Ensure Port Based 802.1x is enabled under Configuration > Advanced Settings.

Click

Port Access Entity > PAE System Control > Initialize Port(s) to open the following window:

Figur

e 6- 79. Initialize Port window (Port-based)

This window allows you to initialize a port or group of ports.The

Initialize Port Table in the bottom half of the window displays the current status of the

port(s).

This window displays the following information:

Parameter Description

Unit Choose the Switch ID number of the Switch in the switch stack to be modified.

From and To Select ports to be initialized.

A r

ead onl

y field indicating a por

t on the Switch.

Auth PAE State The Authenticator PAE State will display one of the following: Initialize, Disconnected, Connecting,, Authenticating,,

Authenticated

, Aborting, Held, ForceAuth, ForceUnauth, and N/A.

Backend State The Backend Authentication State will display one of the following: Request, Response, Success, Fail, Timeout, Idle,

Initializ

and

N/A.

Port Status The status of the controlled port can be Authorized, Unauthorized, or N/A.

Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 196 197

Pas de commentaire

Allied-telesis AT-9724TS Manuel d'utilisateur Page 90