Allied-telesis AT-8203 Manuel d'utilisateur télécharger pdf (Page 15)

AT-8202 and AT-8203 Installation Guide

Installing the Accelerator Card

Before following these procedures, make sure the uplink card is already

installed in the lower slot.

1. Using a #1 Phillips screwdriver, remove the screw that secures the

cover plate to the uplink panel (Figure 8).

Figure 8:

Cover Plate Removal for Top PCI Slot

2. Insert the accelerator card into the top PCI slot and ensure that it is

fully seated. Line up the back edge of the accelerator card with the

card guide, as shown in Figure 9.

Figure 9:

Accelerator Card Insertion

3. Seat the accelerator card firmly in the top PCI connector.

4. Using the screw from Step 1, secure the accelerator card to the chassis.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Pas de commentaire

Allied-telesis AT-8203 Manuel d'utilisateur Page 15