Allied Telesis AR450S Spécifications télécharger pdf (Page 23)

Installation and Safety Guide 23

613-000313 Rev B

To display help on a specific topic, enter:

help topic

Alternatively, type a question mark (?) at the end of a partially completed

command to see a list of valid options.

4. Save the configuration.

Save your configuration to a new file, using the command:

create config=filename.cfg

and set the router to load this file when it restarts, using the command:

set config=filename.cfg

We recommend leaving the boot.cfg file unchanged, in case you need to revert

to the original default configuration.

Connecting Data Cables to AR415S

Connecting the router to your network:

1. Connect to the LAN

If you have not already done so, use straight-through Ethernet patch cables to

connect the device(s) on your private network (LAN) to the router’s switch

port(s). By default, all switch ports are members of VLAN1.

2. Connect to the WAN.

Caution If you intend to use a firewall, configure it before you activate

the WAN link.

Once initial configuration is complete, connect the router to the WAN:

• Connect a PIC port to a WAN connection. See the Port Interface Card Quick

Install Guide and Hardware Reference.

• Use an Ethernet patch cable to connect the router’s Ethernet WAN (ETH0)

port to the Ethernet port of a WAN device (such as a modem).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

Pas de commentaire

Allied Telesis AR450S Spécifications Page 23