Allied Telesis Patch 1 AT-S63 Guide de l'utilisateur télécharger pdf (Page 4)

AT-S63 Version 4.0.0 Patch 2 Software Release Notes

PN 613-001166 Rev A 4 Allied Telesis, Inc.



The management software has a new command line interface based on the commands in the

AlliedWare Plus™ operating system found on other Allied Telesis products, such as the Layer

3 switches. If you are already familiar with the commands in the AlliedWare Plus™ operating

system, you may find this new interface more convenient to use than the standard command

line. Some of the management functions you can perform with this new interface are:

— Configure port parameters, such as Auto-Negotiation, speed, and duplex mode

— Create new tagged and untagged VLANs

— Create access control lists and Quality of Service policies

— Create routing interfaces

— View the MAC address table and add static addresses

Note:

This version of the AT-S63 Management Software supports only a limited number of

AlliedWare Plus™ commands. For further information, refer to the latest version of the

AT-S63 Management Software Command Line Interface User’s Guide.

AT-9400 Stacks

Here are the new and enhanced features in AT-S63 Management Software for AT-9400 Stacks:

 BOOTP/DHCP Relay Agent

 Access Control Lists

 Quality of Service policies

 IPv4 static routes

 Encrypted remote web browser management sessions with the Secure Sockets Layer

protocol and the Public Key Infrastructure protocol

 Encrypted remote Secure Shell protocol management sessions

 AlliedWare Plus™ Command Line Interface. For a description, refer to “Stand-alone AT-9400

Switches” on page 3.

 Stacks now support up to three manager sessions at one time. To adjust this feature, which

has a default setting of one manager session, use the SET SYSTEM command.

 The LOAD command in the standard command line interface has a new parameter that will

make it easier in future releases of the AT-S63 Management Software to update the AT-9400

Switches of a stack. In previous versions, you had to disassemble a stack and update the

switches individually. But with the new MODULE parameter, you’ll be able to update the

management software on all the switches in a stack simultaneously.

Note:

The new MODULE parameter can only be used on stacks that already have Version 4.0.0 or

later. To update member switches that have versions earlier than 4.0.0, you have to

disconnect them from the stack and update them as stand-alone units.

1 2 3 4 5 6 7 8 9 ... 18 19

Pas de commentaire

Allied Telesis Patch 1 AT-S63 Guide de l'utilisateur Page 4