Allied Telesis AT-FS705LE Guide d'installation télécharger pdf (Page 27)

AT-FS705LE Installation Guide

6. Attach the data cables to the switch ports. Do

not use a crossover cable to connect

workstations or servers to ports 1 through 5.

Do not use a crossover cable to connect

another switch or hub to the Uplink port.

Note

You can use either Port 5 or the Uplink

port, but you cannot use both

simultaneously.

7. Power ON the end-nodes.

8. Check that the LINK/ACT LEDs for each port

on the switch are green. If the LEDs are OFF,

refer to “Troubleshooting” on page 16 for

instructions.

The switch is now ready for use.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 45 46

Pas de commentaire

Allied Telesis AT-FS705LE Guide d'installation Page 27