Allied Telesis AT-FH705E Guide d'installation télécharger pdf (Page 28)

14

5. Attach the data cables to the switching hub

ports. Do not use a cross-over cable to connect

workstations or servers to ports 1 through 5.

Do not use a cross-over cable to connect

another switch or hub to the Uplink port.

Note

You can use either port 5 or the Uplink

port on an AT-FH705E Switching Hub,

but you cannot use both simultaneously.

6. Go to the procedure “Verifying and

Troubleshooting the Installation” on page 16.

Installing the Unit on a Wall

For wall-mount installation, you can position

the device vertically or horizontally on the wall

using the keyhole cutouts in the bottom of the

hub chassis.

1. If previously attached, remove the rubber feet

and all cables and the DC power cord from the

device.

2. Select a wall location for the device.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 50 51

Commentaires sur ces manuels

Pas de commentaire