Allied-telesis AT-VIEW PLUS 2.4 INSTALLATION Manuel d'utilisateur télécharger pdf (Page 4)

Allied Telesyn AT-VIEW PLUS 2.4

INSTALLATION GUIDE

1 INTRODUCTION

This Installation Guide describes the installation, configuration, and registration procedures for AT-View

Plus 2.4 on Windows and UNIX. It also describes the system requirements for the application. AT-View

Plus includes the AT-View Plus application for managing Allied Telesyn devices, the MIB browser Amigo,

the MIB Compiler and VLAN Manager.

2 SYSTEM REQUIREMENTS

The following software and hardware components are required to run AT-View Plus 2.4. Make sure that

your system meets these requirements before installing AT-View Plus 2.4.

2.1 Windows

Hardware Pentium based PC, 64MB RAM (128MB+ recommended)

CPU Pentium 166MHz or greater (400MHz+ recommended)

Operating System 32-bit Windows: Windows NT 4.0 (SP6a or later), Windows 2000 (SP3

or later), Windows XP (SP1 or later), Windows 2003

Video 1024 x 768 pixels, 64K or more colors

Supported NMS HP OpenView Network Node Manager v6.20; SNMPc 5.1.6c and 6.0;

Tivoli NetView 7.1.3

Hard Disk Space 70MB or greater (140MB or greater HDD space is temporarily required

during installation)

2.2 Solaris

Hardware SPARC station 20 or UltraSparc series (UltraSparc recommended),

128MB RAM (256MB recommended)

Operating System Sun OS 5.8/Solaris 8 (32-bit version)

Video 64K or more colors

Supported NMS HP OpenView Network Node Manager v6.20

Hard Disk Space 90MB or greater (at least 15MB of SWAP area is required during

start-up; 180MB HDD space is temporarily required during installation)

2.3 HP-UX

Hardware HP 9000 Workstations, HP Visualize Workstations, 128 MB RAM (256

recommended)

Operating System HP-UX 11 (32-bit version)

Video 64K or more colors

Supported NMS HP OpenView Network Node Manager v6.20

Hard Disk Space 180MB or greater (at least 15MB of SWAP area is required during

start-up; 360MB HDD space is temporarily required during installation)

PN 613-50508-00 Rev D Page 4 of 26

1 2 3 4 5 6 7 8 9 ... 25 26

Pas de commentaire

Allied-telesis AT-VIEW PLUS 2.4 INSTALLATION Manuel d'utilisateur Page 4