Allied-telesis AT-VIEW PLUS 2.3 INSTALLATION Manuel d'utilisateur télécharger pdf (Page 16)

Allied Telesyn AT-VIEW PLUS 2.3

INSTALLATION GUIDE

6 INTEGRATING AT-VIEW PLUS 2.3 WITH SNMPC

The AT-View Plus 2.3 installer automatically detects if SNMPc is installed and will perform the necessary

integration so that AT-View Plus 2.3 can be started from within SNMPc. If AT-View Plus 2.3 is installed

before SNMPc, integration will not take place. Reinstallation of AT-View Plus 2.3 will be required.

When SNMPc is running, double clicking on a device that is not supported by AT-View Plus launches

SNMPc’s BitView program. Double clicking on a device supported by AT-View Plus launches the AT-View

Plus application and loads the information for the selected device.

If you are using SNMPc version 5.1.6c and you launched SNMPc for the first time after integration with

AT-View Plus 2.3, a message box appears informing you that the newly detected MIB files will be

compiled. Click Done after compilation process is completed. For SNMPc version 6.0, compilation of

MIB files is done automatically.

If a device icon is displayed as a computer in SNMPc, double clicking it may not launch AT-View Plus 2.3.

In this case, poll the device to change its icon to an ATI product icon then double click the icon again.

PN 613-50508-00 Rev C Page 16 of 26

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Pas de commentaire

Allied-telesis AT-VIEW PLUS 2.3 INSTALLATION Manuel d'utilisateur Page 16