Allied-telesis AT-S62 Manuel d'utilisateur Page 250

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 372
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 249
Chapter 19: SNMPv3
250 Section III: SNMPv3
A warning message is displayed. Click OK to remove the Target
Parameters Table entry.
6. To save your changes, select the Save Config menu selection.
Modifying a
Target
Parameters Table
Entry
To modify an SNMPv3 Target Parameters Table entry, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 77 on
page 246.
5. Click the circle next to the Target Parameters Table entry that you
want to change. Then click Modify.
The Modify SNMPv3 Target Parameter Table Page is shown in Figure
79 on page 250.
Figure 79. Modify SNMPv3 Target Parameters Table Page
Vue de la page 249
1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 371 372

Commentaires sur ces manuels

Pas de commentaire