Allied-telesis AT-MCF2012LC/1 Manuel d'utilisateur télécharger pdf (Page 47)

AT-MCF2012LC and AT-MCF2012LC/1 Media Converter Modules Installation Guide

Installing the Media Converter Module

Caution

A media converter module is sensitive to and can be

damaged by electrostatic discharge. Wear a

grounding device and observe electrostatic discharge

precautions when installing a media converter module

in the chassis.

Note

The AT-MCF2012LC and AT-MCF2012LC/1 modules

support hot swapping. They can be installed while the

chassis is powered on.

Note

There are no adjustable switches on the circuit boards

of the AT-MCF2012LC and AT-MCF2012LC/1

modules.

To install the media converter module, perform the following

procedure:

1. Select a slot in the chassis for the media converter

module. Refer to the chassis’ Installation Guide for the

number and location of the media converter module

slots.

Note

Unless the chassis’ Installation Guide states

otherwise, the AT-MCF2012LC and AT-MCF2012LC/1

media converter modules can be installed in any

available media converter module slot in the chassis.

2. Using a cross-head screwdriver, loosen the two captive

screws that secure the blank panel over the media

converter slot and remove the panel from the chassis.

Refer to Figure 9.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 63 64

Pas de commentaire

Allied-telesis AT-MCF2012LC/1 Manuel d'utilisateur Page 47