Allied-telesis AT-MC103ST/FSx Manuel d'utilisateur télécharger pdf (Page 26)

Installing the Media Converter

11. Set the MDI/MDI-X button as follows:

❑ If you are connecting a workstation to the 100Base-TX port, set the

MDI/MDI-X button to the MDI-X (OUT) position. MDI-X is the default

position.

❑ If you are connecting a hub or a switch to the 100Base-TX port, set the

MDI/MDI-X switch to the MDI (IN) position.

Note

After a using the MDI/MDI-X button to change between the two

settings, you must reset the media converter by powering OFF then

powering ON the unit.

12. Power ON the end-nodes.

The media converter is now ready for use.

Warranty Registration

When you finish installing the product, you should register your product by

completing the enclosed warranty card and sending it in.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Pas de commentaire

Allied-telesis AT-MC103ST/FSx Manuel d'utilisateur Page 26