Allied-telesis AT-GS924 Manuel d'utilisateur télécharger pdf (Page 27)

AT-GS916 and AT-GS924 Gigabit Ethernet Switches Installation Guide

Installing the Switch in a Rack

Perform the following procedure to install the switch in a standard

19-inch rack. If you are not installing the switch in a rack, go to the next

procedure.

1. Place the unit upside down on a level, secure surface.

2. Using a flat-head screwdriver, remove the snap-on plastic feet from

the bottom of the switch, as shown in Figure 10.

Figure 10. Removing the Feet

3. Turn the switch over.

4. Attach the two rackmounting brackets (provided) to the sides of the

switch using the bracketmounting screws (provided), as illustrated in

Figure 11.

Figure 11 Attaching Rackmounting Brackets

AT-GS916GB

10/100/1000Base-T Gigabit Ethernet Switch with GBIC Uplinks

100

LINK/ACT

FDX

1000

345678

516

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 49 50

Pas de commentaire

Allied-telesis AT-GS924 Manuel d'utilisateur Page 27