Allied-telesis AT-FS708 Manuel d'utilisateur télécharger pdf (Page 27)

AT-FS708 Fast Ethernet Switch Installation Guide

Warning

Power cord is used as a disconnection device: To de-energize

equipment, disconnect the power cord.  5

6. Verify that the POWER LED is green. If the LED is OFF, refer to

“Troubleshooting” on page 33 for instructions.

Note

The switch perform a self-diagnostic test upon power up. This takes

about 20 seconds to complete.

7. Power ON the end-nodes connected to the switch.

8. Check that all the LINK/ACT LEDs are green. If any of the LEDs is

OFF, refer to “Troubleshooting” on page 33 for instructions.

The switch is now ready for use.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 60 61

Pas de commentaire

Allied-telesis AT-FS708 Manuel d'utilisateur Page 27