Allied-telesis AT-FS202SC/FS1 Manuel d'utilisateur télécharger pdf (Page 53)

AT-FS20x Series Installation Guide

2. Place the ferrule tip on the exposed cleaning surface and rub the

ferrule in a downward direction, as shown in Figure 25.

Figure 25. Rubbing the Ferrule Tip on the Cleaning Surface

Note

Rub the ferrule tip on the cleaning surface in one direction only.

3. When you reach the end of the cleaning surface, pick up the ferrule

tip, rotate and place it at the top and rub downwards at least two times.

Caution

Failing to pick up the ferrule tip when you reach the bottom of the

cleaning surface can result in static electricity that can damage the

fiber optic cable.

4. If desired, repeat steps 3 and 4.

5. If a fiber inspection scope is available, use the scope to inspect the

ferrule end face to make sure that it is clean.

6. Reconnect the cable to the port or protect the ferrule tip with a dust

cap.

Note

Always keep a dust cap on a fiber optic cable when it is not in use.

102

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 87 88

Pas de commentaire

Allied-telesis AT-FS202SC/FS1 Manuel d'utilisateur Page 53