Allied-telesis AT-8000S (Layer 2) Manuel d'utilisateur télécharger pdf (Page 44)

Page 44

Allied Telesis AT-8000SSwitch

Installation Guide

Warning

13. Do not strip more than the recommended amount of wire. Stripping more than the recommended

amount can create a safety hazard by leaving exposed wire on the terminal block after installation.

Warning

14. When installing this equipment, always ensure that the frame ground connection is installed first and

disconnected last.

Warning

15. Check to see if there are any exposed copper strands coming from the installed wire. When this

installation is done correctly there should be no exposed copper wire strands extending from the terminal

block. Any exposed wiring can conduct harmful levels of electricity to persons touching the wires.

Warning

17. This system works with positive grounded or negative grounded DC systems.

Warning

18. Only trained and qualified personnel are allowed to install or to replace this equipment.

Caution

19. The attached mounting brackets must be used to securely mount the device on the wall.

Caution

20. Do not install in direct sunlight, or a damp or dusty place.

Caution

21. Do not expose the gateway device to moisture or water.

Caution

22. If the gateway device is installed indoors, make sure that the site is a dust free environment. The site

should provide for easy access to the ports of the gateway device.This will make it easy for you to connect

and disconnect cables, as well as view the LEDs.

1 2 ... 39 40 41 42 43 44 45 46 47 48

Pas de commentaire

Allied-telesis AT-8000S (Layer 2) Manuel d'utilisateur Page 44