Allied-telesis AlliedView-EMS 4.0.2 INSTALLATION Manuel d'utilisateur télécharger pdf (Page 10)

AlliedView™-EMS 4.0.2 INSTALLATION GUIDE Page 10 of 31

Select No and click Next if you do not wish to check for the latest version of

AlliedView-EMS. The installer will then proceed to the next window.

5. If you plan to integrate AlliedView-EMS 4.0.2 with an NMS, the NMS should be in the

correct state:

• For SNMPc and OpenView, services should not be running.

• For NetView, services should be running.

The next window is displayed if the installer has detected that your NMS is not in its

correct state.

If you plan to integrate AlliedView-EMS 4.0.2 with SNMPc or OpenView, select No and

click Next to continue. Selecting No will terminate the installation setup program. You

will then need to stop SNMPc or OpenView services and start the installer again.

If you do not plan to integrate AlliedView-EMS 4.0.2 with SNMPc or OpenView, select

Yes and click Next to continue. The installer will then proceed to the next window.

Note that the opposite applies for NetView. The window will be displayed if NetView

services are not running.

6. Specify whether you want to install both the AlliedView-EMS 4.0.2 application and its

documentation. You also have the option to install either the application or the

documentation only.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Pas de commentaire

Allied-telesis AlliedView-EMS 4.0.2 INSTALLATION Manuel d'utilisateur Page 10