Allied-telesis AlliedView-EMS 4.0.2 Device-Manager Manuel d'utilisateur télécharger pdf (Page 412)

100

101

AlliedView™-EMS 4.0.2 Device Management Guide Page 412 of 441

Note - The value of the Port Speed parameter of a port with an established link

automatically changes to '10Mbps' when the value of its Port Mode parameter is

changed from 'auto' to 'manual'.

Note - The current firmware version does not allow the Port Ingress Rate Limit and

Port Egress Rate Limit parameters to be configured.

Note - AT-CV5M01: The current firmware version does not allow Port Speed and

Port Duplex Status parameters to be set to '1Gbps' and 'unknown' values

respectively.

AT-CM70S

4 x TI/E1 + 10/100TX over SFP-based fiber.

LED State Description

DUP

Green

Orange

The port is operating in full-duplex mode.

The port is operating in half-duplex mode.

LT Green Link Test is enabled

OAMB Green OAM Bypass is enabled

OAMV Green OAM Visible is enabled

LCDS Green Line Card Dip Switch is enabled

Note - The current firmware version will not allow remote port connection on the RJ-45

port if the SFP port is set to disabled.

Note - The Module Name parameter always displays 'yyyyyyyy' as its default value when not

yet configured.

1 2 ... 407 408 409 410 411 412 413 414 415 416 417 ... 440 441

Commentaires sur ces manuels

Pas de commentaire

Allied-telesis AlliedView-EMS 4.0.2 Device-Manager Manuel d'utilisateur Page 412

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Allied-telesis AlliedView-EMS 4.0.2 Device-Manager