Allied-telesis FastHub16 Manuel d'utilisateur télécharger pdf (Page 14)

Installation

4. Pry off the interlock cap at each corner of the unit. Refer to Figure 4. From

the side of the unit, insert the tip of a small straight-slot screwdriver into

the opening of the interlock cap. Press down on the screwdriver to pry the

cap off.

Figure 4

Interlock Cap

5. Place the next unit over the base unit, aligning with the interlock cap and

press down on each corner to snap the units together.

6. Repeat steps 4 and 5 until all units are in the assemblage.

7. Continue with “Powering on the Hub.”

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Pas de commentaire

Allied-telesis FastHub16 Manuel d'utilisateur Page 14