Allied-telesis AT-S88 Manuel d'utilisateur télécharger pdf (Page 54)

Chapter 5: SNMP

Setting Up the SNMP Community Table

To define the SNMP community names and their settings, perform the

following procedure:

1. From the main menu, select SNMP > Community Table.

The Community Table page is shown in Figure 13.

Figure 13. (SNMP) Community Table Page

2. To add a community name, enter it in one of the Community Name

fields.

3. To allow read/write access for any community name, click the

adjoining box in the Set column.

If you do not click Set for a particular community name, that

community name has read access only.

4. Do one of the following:

 Click OK to save the community names.

 Click Reload to clear the fields and start over.

5. To permanently save these settings in the configuration file, from the

main menu, select Save Configuration.

The Save Configuration page is shown in Figure 3 on page 13.

6. Click Save.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 157 158

Pas de commentaire

Allied-telesis AT-S88 Manuel d'utilisateur Page 54