Allied-telesis AT-S100 Manuel d'utilisateur Page 165

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 274
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 164
AT-S100 Management Software User’s Guide
Section I: Command Modes 165
CHANNEL-GROUP
Syntax
channel-group <1-10> mode active|passive
no channel-group
Parameters
<1-10> Specifies a channel group. Enter a value between 1 and 10.
mode Specifies the status of LACP negotiation on a port. Choose
from the following:
active Enables initiation of LACP negotiation on a port.
passive Disables initiation of LACP negotiation on a port.
Description
Use the CHANNEL-GROUP command to create a channel-group and
enable or disable LACP negotiation on a port. To remove a channel group
from an interface, use the no form of this command.
Command Mode
Interface Configuration mode
Example
The following commands create channel group 3 and make it active on
interface 20:
switch# configure terminal
switch(config)# interface ge20
switch(config-if)# channel-group 3 active
Related Commands
“SHOW RUNNING-CONFIG” on page 153
“SHOW STATIC-CHANNEL-GROUP” on page 109
Vue de la page 164
1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 273 274

Commentaires sur ces manuels

Pas de commentaire