Allied-telesis AT-MCF2000S Manuel d'utilisateur télécharger pdf (Page 20)

Chapter 1: Installation

Figure 3. Changing the DIP switch

5. Align the edges of the module with the guides in the slot and

carefully slide the module into the chassis until it is flush with

the back panel of the chassis. See Figure 4 on page 21.

You may need to exert light pressure to seat the module on

the connector on the back panel of the chassis.

Caution

Do not force the module into place. Doing so may damage

the connector pins on the backplane inside the chassis. If

there is resistance, remove the module and reinsert it after

verifying that the edges of the card are properly aligned in the

guides.

T-MCF2000S

CK 1

INKA

PORT ACTIVITY

CK 2

CHAS

SIS ID

1265

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Pas de commentaire

Allied-telesis AT-MCF2000S Manuel d'utilisateur Page 20