Allied-telesis AT-MCF2000 Manuel d'utilisateur télécharger pdf (Page 35)

AT-MCF2000 Multi-channel Media Converter Chassis Installation Guide

Installing a Media Converter Module

This section contains general instructions on how to install a

media converter module in the chassis. For specific

installation and cabling instructions, refer to the Installation

Guide that ships with the media converter module.

Caution

A media converter module is sensitive to and can be

damaged by electrostatic discharge. Wear a

grounding device and observe electrostatic discharge

precautions when installing a media converter module

in the chassis.

Note

Refer to the Installation Guide that ships with the

media converter module for the following information

before you install the module in the AT-MCF2000

chassis:

 Determine if the module supports hot swapping. If

the module does not support hot swapping, you

must power off the chassis before installing the

module.

 Determine if there are any DIP switches on the

circuit board of the media converter module that

need to be set. If there are switches, set them in

accordance with your network requirements by

following the instructions in the module’s

Installation Guide.

 Determine if the module has a battery with an

insulator that must be removed prior to

installation. If there is an insulator, remove it by

following the instructions in the module’s

Installation Guide.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Pas de commentaire

Allied-telesis AT-MCF2000 Manuel d'utilisateur Page 35