Allied-telesis AT-CM70S Manuel d'utilisateur télécharger pdf (Page 108)

Appendix B: Cleaning Fiber Optic Connectors

108

3. When you reach the end of the cleaning surface, pick up the ferrule tip,

rotate and place it at the top and rub downwards at least 2 times.

Caution

Failing to pick up the ferrule tip when you reach the bottom of the

cleaning surface can result in static electricity that can damage the

fiber optic cable.

4. If desired, repeat steps 1 and 2.

5. If a fiber inspection scope is available, use the scope to inspect the

ferrule end face to make sure that it is clean.

6. Reconnect the cable to the port or protect the ferrule tip with a dust

cap.

Note

Always keep a dust cap on a fiber optic cable when it is not in use.

Note

Do not touch the end face of the ferrule in the connector.

Warning

Do not look directly at the cable ends or inspect the cable ends with

an optical lens when the cable is connected at the other end.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 135 136

Pas de commentaire

Allied-telesis AT-CM70S Manuel d'utilisateur Page 108